Garage Door Opener Repair Concord

Garage Door Opener Repair Garage Door Repair Garage Door Services Garage Door Opener Installation

Project Description

Palms Garage Doors was contacted for a garage door opener repair by a homeowner in Concord, CA. Their garage door opener was running, but the door was not opening. Our technician noted that the screw-drive assembly was not moving even though the motor had power and the switch worked. Upon inspection of the opener unit, our technician discovered that the coupler that connected the operator motor and the screw drive rail got fatigued over time and broke off. Fortunately, we had a compatible coupler in stock, so we were able to replace the broken component and got the garage door fully functioning again later on in the day.

The garage door opener is one of the most critical aspects of a residential garage door system, and your garage door will not open and close properly without a functioning opener. A garage door opener has various components, including the motor, gear, logic board, radio receiver, chain/belt, and others. When all of these components are in good working order, they will work together to give you the convenience of operating your garage door with just a press of a button. When your garage door opener suddenly stops working properly, the cause may not be apparent, and the solution is not so straightforward.

Common garage door opener problems:

The opener does not respond to the wall switch

Your garage door may not respond to your remote or wall switch for a number of reasons. The most likely cause is that the power supply has been compromised. It is possible that the motor unit has been unplugged or the door opener circuit’s circuit breaker, fuse, or GFCI outlet has tripped or burned out. It’s essential to consult a specialist if you are not sure what the problem is.

The opener does not respond to the remote control or mounted keypad

Your garage door opener may stop working for a range of factors. For example, modern garage door openers use radio frequencies, and a few extra feet can significantly affect the signal strength. In addition, the antenna inside the garage may be out of range. Alternatively, the batteries in the remote control or keypad may need to be replaced. It is also possible that the remote control or keypad’s delicate circuitry may lose its setting and need to be reprogrammed.

The garage door does not fully close

If your garage door is not closing all the way, you may need to adjust the close limit switch. If the close limit switch is set incorrectly, it can stop the door from closing or cause the opener to reverse or pull back up when you try to close it. Adjusting or realigning the safety sensors may also be necessary.

The garage door closes but reverses before hitting the floor

There are a few different issues that could be causing your garage door to reverse before it ever reaches the floor. First, the close-force may need to be adjusted to the right setting. Damaged or rusty rollers can also cause excessive friction, fooling the door opener into believing it needs to stop sooner.

The garage door operates poorly in cold weather

If your garage door refuses to open in colder weather, you can vary the sensitivity by adjusting a screw on the motor unit. The opener may refuse to operate due to stiff rollers. This problem can also be solved by lubricating the rollers. Because each technique for increasing sensitivity differs, check your owner’s handbook for exact instructions.

Garage door opener repair near me

Are you looking for a reliable garage door service in the Greater Bay Area? Palms Garage Doors has you covered! We are a top-notch garage door company that offers quality services at affordable prices. Whether you are dealing with a broken spring, broken garage door opener, or your door needs some maintenance, our team of experts will get the job done right. Plus, we offer convenient scheduling so you can get your garage door repaired or replaced on your schedule. No job is too big or small for us - we are here to serve you! Call us today for more information!

Project Gallery

Recent Projects

Comments

Location

Walnut Ave Concord, CA, US, 94519

Powered by LocalWiz.app
Contact Us
Palms Garage Doors
1729 N First St
Unit 11213
San Jose, CA 95112
(833) 833-3361

Visit our Facebook Page
Call Now ButtonCall Now